EasyCap Driver Installation EasyCap Driver Installation The user has to install the Easy Cap driver fir st before recording any video files with Easy Cap. The Easy Cap driver can be accessed in the disk attached with Easy Cap Device or by online download. Minecraft 0.11 0 apk free download. ( Please go to th e below address for downloading: ) Tip: Pl ease do not plug Easy Cap into your computer when you are installing the driver. Please disconnect the Easy Plug from your computer if it was accidentally connected with the computer during the process of the driver installation. 1, Install the driver by th e disk. A, P u t the disk into the computer. The system will run the disk automatically, and the installation screen will pop up as below. Please choose “ Install Driver ” and follow the instructions. B, Click “ Install ” to begin the installation. Easy Driver Pro makes getting the Easycap Drivers a snap. Easy Driver Pro will scan your computer for missing, corrupt, and outdated Easycap Drivers. Easy Driver Pro makes keeping your Easycap Drivers update to date so easy even a child can use it. There is a newer version for the Easycap that has version 6.10.70.001 dated and that is supposedly working on Windows 7 (both 32-bit and 64-bit). It's the Syntek STK 1160 model. If you want to review or change any of your installation settings, click Back, Click Cancel to exit the wizard. C, T h e screen of Setup Status as below indicates the installation status. It will take a few minutes to finish installation. You can stop installation by click “ Cancel ”. D, T he InstallShield Wizard has successfully installed USB2.0 Capture Device. Click Finish to exit the wizard. E, Please pay attention to the reminding notes after the installation of the driver as following. 2, Install by online download A, Open the downloaded folder and double click “ Setup.exe ” to run the installation program. B, USB2.0 Capture Device Setup is preparing the InstallShield Wizard, which will guide you through the rest of the setup process. Tip: If you ha ve plugged this device on the computer, please up-plug it before continuing the installation. C, Click Install to begin the installation. If you want to review or change any of your installa tion settings, click Back, Click Cancel to exit the wizard. D, The screen of “ Setup Status ” indicates the status of installation as followed. The setup process will take a while. You can quit the installation by clicking “ Cancel ”. Tip: Please choose “ Continue Anyway ” if the following remind information emerges. E: Please wait until the system finishes copying the relevant driver files. When the copying is finished, the installation is finished. Click Finish to exit the wizard. Tip: Please note the following remind information when the installation is finished. 3, Use “ Found New Hardware Wizard ” to install the Easy Cap driver. Whe n the Easy Cap is connected to the computer, “ Found New Hardware Wizard ” will be initiated automatically. A, When the user chooses “ Install the software automatically (Recommend), the system will locate and run the driver installation file automatically. Tip: Please choose “ Continue Anyway ” if the below reminding pops up. The system will find the driver and start the installation. B, I f the user chooses “ Install from a list or specific location(advanced) ”, the following steps will be initiated manually. Choose where the driver will be installed by browsing. Tip: Please choose “ Continue Anyway ” when the following r emind emerges. Windows diagnostic tools. The system will find the driver and start the installation. It will take a while until the installation finishes. The wizard has finished installing the software for syntek stk1150. Click finish to close the wizard. Download sirine polisi patwalk.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |